Home > Not Working > Earphone Jack On Iphone Not Working

Earphone Jack On Iphone Not Working


Replace the two screws holding the battery cable down using your #000 Phillips screwdriver. 10. In some cases, loud speaker audio won't work because your iPhone thinks headphones are plugged in when they're really not. Forums iPhone iPad Mac Apps Games Features Reviews Virtual Reality Help & How To Question & Answer Contests Shop now! Then set up a Genius Bar appointment to get it fixed. have a peek here

This means you'll be replacing the entire dock in order to restore functionality. 1. Submit Cancel One Moment Please Thanks for your feedback. 14% of people found this helpful. One you're sure your iPhone is turned off, proceed to the next section. 3. Test sounds both from your ringer, loud speaker on a call, and music or some other kind of audio. http://www.imore.com/how-replace-broken-headphone-jack-iphone-5s

Iphone 6 Headphone Jack Not Working

Close Yeah, keep it Undo Close This video is unavailable. The iPhone is a complex and delicate device, which makes it hard for laypeople to repair. Once all four screws are removed, carefully remove the shield and set it aside. Podcasts Contact iMore About iMore Android Central Connectedly CrackBerry iMore Windows Central Tesla Central VR Heads MrMobile Upgrading made easy How to transfer data to your new iPhone 7 This could

  • Now remove the three screws shown in the photo below using your #000 Phillips screwdriver.
  • Flip up the rubber gasket shown in the photo below as well.
  • Use your #000 Phillips screwdriver for this.
  • It would be best if it's the headphones: it's generally cheaper to replace headphones than to do a complex hardware repair to the jack.The easiest way to do this is to
  • If the bars on the Ringer screen are low, you may not be able to hear through your headphones.
  • If everything appears to be aligned correctly with the replacement, continue on to finish re-assembling your iPhone 5s. 8.
  • The last thing you'll need to do is transfer the Touch ID connector — which is highlighted below — to the new dock assembly.
  • All iPhone DIY repair guides Like us!
  • One you're sure your iPhone 5s is turned off, proceed to the next section. 3.

There are some internal differences you'll have to watch out for, which makes this repair slightly different. Freeze HD 7,027,867 views 10:02 Repairing Headphones with Microphone (TRRS Plug) - Duration: 8:38. Put a little bit of rubbing alcohol on the end you removed the cotton from and then insert that end into the headphone jack. Iphone Headphones Controls Not Working Power off your iPhone 5s Before performing any repair on any device, always remember to power it off.

Use your 5-point security screwdriver to remove them. Iphone 5 Headphone Jack Not Working Cleaning the jack often forces the iPhone back in to regular audio mode. This is a slightly intricate repair and you'll have to take care not to snag or tear any cables. here Carefully examine the teeth on the bottom, as one slides underneath where the Touch ID sensor connects and the other goes underneath the bottom right of the logic board.

Remove the four screws holding down the shield that covers the display cables. Apple Headphones Mic Not Working It's just held on with a bit of adhesive. You can also lay the adhesive on the right side of the dock at this time and re-connect the cable to the logic board to ensure a good fit. To remove debris, gently brush all openings with a small, soft-bristled brush that's clean and dry.

Iphone 5 Headphone Jack Not Working

Take note of the location of each screw as they are all different sizes and are not interchangeable. http://www.imore.com/how-replace-headphone-jack-your-iphone-ultimate-guide iPhone 5s An iPhone 5s headphone jack replacement is very similar to both the iPhone 5 and iPhone 5c. Iphone 6 Headphone Jack Not Working You only want to separate the screen about an inch at this point. Headphone Jack Not Working Iphone 6s They are both the same size, so it's okay if you mix them up. 4.

Sign in to report inappropriate content. http://tubemuse.com/not-working/earphone-not-working-on-iphone.html Pay attention to the adhesive that is holding it down. If you can't push one or the other in all the way (or both), the dock is lined up incorrectly and needs to be repositioned. You'll need to remove the two off to the far right in order to reveal the third and final cable, which sits below them. Iphone Headphone Jack Not Working Properly

Good luck! Do NOT pull up all the way at this point, as the cable that runs to the Touch ID sensor is still connected. It's quite easy to break but take your time so you don't break the cable itself. Check This Out The simplest way to test this is to:Open Control CenterTap the Bluetooth icon in the top row (it's in the center) so that it's not lit up.

If all of the above checks out okay, give yourself a pat on the back, you successfully fixed your iPhone 5s headphone jack! 12. Iphone Headphones Not Working In One Ear All the links below will route you to the direct item on eTech's site. We recommend using plastic razor blades if you can find them, since they won't cause damage to the finish of the iPhone's frame. 5.

Neither worked as well as the humble cotton swab, which successfully exorcised what he believes was lint that had been picked up from his pocket.

Sent from the iMore App 0 1 year ago Reply kioki http://clashofclans-cheats2016.blogspot.com/ Und wie in jeder Schlacht, nachts bietet vor- und Nachteile in einem Gameplay. Try Other HeadphonesThe first thing you should do when trying to fix a broken headphone jack is to confirm that the problem is actually with your headphone jack, rather than the Re-connect the Touch ID cable to the logic board. Headphone Controls Not Working Android Best Raspberry Pi projects for iPhone Do it yourself How to fix a broken iPhone 6 screen in 10 minutes DIY How to replace a broken iPhone 5 screen in under

Remove the two security screws on both sides of the dock connector There are two security screws that secure your device's screen to its frame, and they sit on each side Working... Power off your iPhone 5s Before performing any repair on any device, always remember to power it off. this contact form If any of this sounds like something you're experiencing, a DIY iPhone repair can not only save the day, if you're out of warranty, it'll cost a heck of a lot

When I called customer service they said I need to bring it in to diagnose the problem. Remove the five screws shown below that are holding the Lightning dock to the casing. Forums iPhone iPad Mac Apps Games Features Reviews Virtual Reality Help & How To Question & Answer Contests Shop now! The display assembly should now be free from the body of the phone.